What is the B/O column, and what if the vendor only sends part of my order?
B/O stands for Back Order. The tooltip on the column says it exactly: "Back Order. This is the quantity that your vendor will ship you later."
So when the driver turns up with less than you ordered, you do not edit the quantity you ordered. You put the shortfall in B/O.
Example: you ordered 5 brake pad sets at $120 and only 3 arrived.
Leave QTY at 5.
Type 2 in B/O. The line total immediately drops from $600.00 to $360.00 — you are only being billed for what turned up.
Click Receive, put the vendor's invoice number in Reference Number, and click Receive.
What happens to the order after that?
EasyTruckShop splits the PO into an Order Group — one PO number, two orders inside it, shown in the Linked Orders panel on the right:
732 — Received, with the reference number and the $360.00 you actually got
732 — Ordered, holding the $240.00 still owed to you
Click Overview in that panel to see the whole picture at once: ORDERED, RECEIVED and STATUS per line, so you can see 3 of 3 ticked off and 2 still Ordered.
When the rest arrives, open the Ordered order in that group and receive it. Nothing has to be re-typed.
And on the service?
The job's single 5 ea. line becomes two lines: 3 ea. Received and 2 ea. Ordered, both showing the same PO number. The technician can start on the three that are here.
⚠️ Receiving more than the job asked for is not blocked. If you raise the QTY on a service-destined line above what the job needs, the extra goes onto the job too — not into inventory — and you get no warning. A job that asked for 5 can quietly end up with 6, and the customer is billed for it. If you bought extra on purpose, put the extra on its own line with the destination set to Inventory.
Related Articles
Previous step: Parts Flow: Purchase Order Statuses and Whether to Receive into Inventory or the Service
Related:



